If there is no paper jam or if recovering the paper jam does not resolve the problem, then replace the Automatic Roll System (the error could be caused by anything that stalls the motor).Ĭorrective Action: Replace the Automatic Roll System (the error could be caused by anything that causes the home position not to be detected or not to be the correct one - electrical sensors, internal mechanical problems, etc.).Ĭorrective Action: Replace the Carriage Motor Assembly -29.Įrror during the calibration of the motor encoder system or a problemįinding the zero position on the Encoder Disc. Plug in the power cable again and check if the Error Code has disappeared. If this error code was caused by a paper jam, unplug the power cable from the printer and clear the blockage. If the Error Code continues, replace the Cleanout Assembly.
#Error code 17099 install#
Remove the Cleanout Assembly and install it again correctly. No Cleanout Assembly detected while loading media. If the Error Code continues, replace the Carriage Assembly -35.Ĭorrective Action: Replace the Service Station Assembly -24.Ĭorrective Action: Replace the Ink Supply Station -14. Reconnect the Trailing Cable correctly to the Electronics Module. Using this procedure you will be able to determine exactly which component failed. Only replace one component at a time and check if the error has gone before replacing another component. If the Error Code continues, replace the Electronics Module -18.
#Error code 17099 manual#
HP Designjet Ultra Low End Printer Service Manual
If the error code continues, refer to the Jetdirect Card Service Manual and Service Notes.Ĭorrective Action: Reconnect the Front Panel.
If an emergency firmware upgrade is NOT possible or it didn’t work, replace the Electronics Module -18.Ĭorrective Action: Replace the Carriage Assembly -35.Ĭorrective Action: Unplug the power cable from the printer and wait a few seconds. If the Electronics Module failed during the firmware upgrade, first perform an emergency firmware upgrade ( -26). If the Electronics Module failed during initialization, you must perform the Electronics Test to determine the cause of the failure. Corrective Action: Replace the Electronics Module -18.Įlectronics Module failed during the firmware upgrade OR the Electronics